Troubleshooting-Gaggia-LogicRS-Alarm-On

If the alarm light is on and not flashing the machine is asking for a minor maintenance item to be completed. Make sure the machine is powered on when doing these maintenance items. The various components trip sensors in the unit which tell the machine the maintenance has been done. If the machine is not powered on the sensors won't reset and the alarm light will remain on.

1. The water tank is empty.
   1. Remove the water tank and refill it.
   2. If the water tank chamber is dirty or has any debris in it, wipe it down.
   3. Firmly reinsert the water tank into the machine.
2. The internal drip tray and grounds drawer are full.
   1. Remove the internal drip tray and grounds drawer.
   2. If the drip tray chamber is dirty or has any debris in it, wipe it down.
   3. Firmly reinsert the grounds drawer and drip tray into the unit.
3. The machine is out of beans.
   1. Check the hopper. If is empty refill it.
   2. If the hopper is full, or you've already refilled it and the light is still not clearing then the grinder may be blocked and need cleaning. This typically happens if beans are being used that are not compatible with the machine. This machine does not accept oily, caramelized, or flavored beans. Use of these beans can cause permanent damage to the machine that is not covered under warranty. These beans can be identified easily. They will be shiny and feel slippery or sticky. Dry beans that are appropriate for the machine will look dull and feel rough.
      1. Do the cleaning and calibration instructions in this document:
      2. After reassembling the machine according to these instructions do not add beans in. First make sure the grinder adjustment knob is set to the coarsest setting, which is the largest dot.
      3. Add beans back into the machine. The beans must be dry, do not add oily beans back into the unit.
      4. If this clears the alarm light and shots are pulling successfully on this grind setting then you can move the grind back to the original setting. Only move the knob one dot at a time, brewing a shot in between each adjustment.
4. If none of these steps have cleared the light then the machine may have a broken sensor and will need to be repaired.