View source for Troubleshooting-Prosumer-Wand-Leak

<includeonly>
====From Steam Wand Or Hot Water Tap====

#'''If either wand is leaking from the end of the wand,''' it means the steam/hot water valve is not fully closed.
#*'''Make sure the knob is securely in the closed position.'''
#*'''If the knob feels loose, or doesn't appear to be properly engaging,''' then there may be a loose or broken part in the knob assembly. {{{knob_instr|}}} {{#ifeq:{{{descalable}}}|Yes
|#*'''Descale the machine according to the instructions in the Cleaning & Maintenance section above.''' Scale buildup inside of the steam/hot water valves will prevent the valves from closing fully.}}
#*'''If the leaking persists,''' then the corresponding valve may need to be replaced. {{{valve_rep_instr|}}}
#'''If the wand is leaking between the tip and the arm of the wand during use,''' there is an o-ring that is broken, missing, or out of position. {{{tip_instr|}}}
#'''If the wand is leaking from the ball joint,''' then there may an o-ring that is worn out or out of position. {{{ball_joint_instr|}}}
{{#ifeq:{{{valve_is_external}}}|Yes
|#'''If water is leaking between the entire wand assembly and the face of the machine,''' make sure the valve assembly is properly secured to the machine. {{{valve_attach_instr}}}
}}
</includeonly>
<noinclude>
This template calls instructions for troubleshooting wand leaks on prosumer units. The descalable parameter should be set to "Yes" if the machine is descalable.

<pre>
{{Troubleshooting-Prosumer-Wand-Leak
|knob_instr         =
|descalable         =
|valve_rep_instr    =
|tip_instr          =
|ball_joint_instr   =
|valve_is_external  =
|valve_attach_instr =
}}
</pre>
</noinclude>