View source for Troubleshooting-Super-Bottom-Leaking

<includeonly>
====From The Bottom====

#Check the internal drip tray and make sure it is not overfilling. If the drip tray full indicator came on, and the trip tray was removed and reinserted but never emptied, it will reset the machine sensor and possibly result in the tray overflowing. {{#switch: {{{tank_load_style}}}
| Top = <br />
#The leaking is coming from the water tank chamber.
##If the water tank is not positioned properly it can cause water to continuously drain from the tank, even while the machine is turned off. This happens when the water tank is inserted far enough to open the release valve, but not far enough to seal with the intake line. This water can leak out from the water tank and end up on the bottom of the machine. This particular issue is usually indicated by lots of clear water leaking onto the counter or into the internal drip tray, even though the machine is powered off. Remove the water tank and make sure there isn't anything, such as coffee beans, which could be blocking the tank from seating properly and then firmly reinsert the tank into the machine and press firmly on it to make sure it creates a good seal with the intake line.
##If the machine only leaks while the water tank is attached, but is properly inserted, then the intake line may be broken or disconnected. This will require a repair.
| Side = }}
{{#ifeq:{{{has_brew_drain}}}|Yes
|#If leaking only occurs while the machine is brewing then the drain area of the machine may be blocked. The drain area relieves excess water from the brewing process and should be cleaned regularly. Use these instructions to clean the drain area: [[File:ALL MODELS Drain Area Cleaning.pdf|250px|thumbnail|center|Drain Area Cleaning Instructions]]
#:If this does not resolve the leaking, then the leaking may be coming from an internal component and the machine should be repaired. }}
</includeonly>
<noinclude>
This template calls instructions for troubleshooting super-automatics machines that are leaking from the bottom. The tank_load_style parameter will alter the instructions depending on whether the tank is leaded from the top of the machine or the side of the machine.

<pre>
{{Troubleshooting-Super-Bottom-Leaking
|tank_load_style =
|has_brew_drain  =
}}
</pre>
</noinclude>