View source for Troubleshooting-Super-Brew-Unit-Stuck

<includeonly>
<h3>{{{section_title}}}</h3>

The machine is sensing that the brew unit motor is working too hard to engage the brew unit. There is a fail-safe built into the machine to prevent itself from damaging the brew unit; instead it will stop and give display an error. This issue is typically resolved through normal maintenance.

#First restart the machine to clear the error message and reset the brew unit back to the home position so that it can be removed. If the machine is in an active rinse cycle do not try to remove the brew unit. The rinse cycle must be completed before the brew unit can be removed. {{#ifeq:{{{has_bypass}}}|Yes
|#If this happened when you were using the bypass function specifically then you may have added too much preground coffee.
##Try running a blank bypass shot. To do this just run a normal bypass shot but do not add any coffee. You should just have plain water come out of the spouts. If the machine successfully completes this cycle then too much coffee was added to the bypass doser previously. The machine only accepts about a maximum of 8-9 grams per shot. The scoop that comes with the machine doses more than this. To make sure you are adding the appropriate amount take one level scoop of preground coffee and remove a large pinch from it. This should about about 8 grams of coffee and should work in the machine.
##If the blank bypass shot also throws an error code restart the machine again and proceed to the next step.}}
#When the machine indicates that it is ready for use open the door to the brew unit chamber.
##Try removing the brew unit. If the brew unit does not readily come out '''''do not''''' force it out. The brew unit is stuck in an engaged position and will need to be properly reset. Forcing it out of the machine can break the brew unit and possibly cause damage other parts. Do the instructions in the following video to get the brew unit properly reset before moving on to the next step. If the brew unit won't reset to the home position the machine may require a repair. {{{brew_stuck_instr|}}}
##If the brew unit is easily removed then rinse it off with cold water and let it dry.
#The brew unit will need to be [[#Brew Unit|cleaned and lubricated]].
#Reinsert the brew unit into the machine and try brewing a shot.
</includeonly>
<noinclude>
This template calls troubleshooting instructions for handling brew unit errors or stuck brew units.

<pre>
{{Troubleshooting-Super-Brew-Unit-Stuck
|section_title    =
|has_bypass       =
|brew_stuck_instr =
}}
</pre>
</noinclude>