Difference between revisions of "Ed/Sandbox"

Revision as of 09:33, 30 September 2020

Error Code	Brief Description	Description
01	blocked coffee grinder	the coffee grinder is blocked (jammed grinder blades or sensor is not reading properly)
03	brewing unit blocked in ‘work’	descending time-out exceeded
04	brewing unit blocked in ‘home’	ascending time-out exceeded
05	blocked water circuit	water does not flow in the flow meter
06	frother unit solenoid valve	short circuit in a solenoid valve of the frother unit
10	coffee boiler short circuit	coffee boiler temperature sensor short circuit
11	coffee boiler in open circuit	coffee boiler temperature sensor in open circuit
12	steam boiler short circuit	steam boiler temperature sensor short circuit
13	steam boiler in open circuit	steam boiler temperature sensor in open circuit
14	various temperature errors (in the coffee boiler)	coffee boiler temperatures out of control
15	various temperature errors (in the steam boiler)	steam boiler temperatures out of control
16	coffee unit short circuit	brewing unit microswitch short circuit
18	clock error	memory fault or impossible to set
19	no zero crossing	no zero crossing on board, could also be caused by the power board

Hardness	Water Hardness	Without Water Filter	With Water Filter
1	Soft water (up to 7°dH)	"Approx. every 6 months / 240 litres"	Approx. every 12 months / 480 litres
2	Medium water (7° - 14°dH)	Approx. every 3 months / 120 litres	"Approx. every 6 months / 240 litres"
3	Medium water (7° - 14°dH)	"Approx. every 6 weeks or 60 litres"	"Approx. every 3 months / 120 litres"
4	"Very hard water (over 21°dH)"	"Approx. every 4 weeks or 30 litres"	"Approx. every 6 weeks or 60 litres"

The default water hardness level is 3. Each litre of water corresponds to approximately 2,000 pulses

Symbol	Brief Description
	Put back the drip tray and coffee grounds drawer; close the service door.
	Coffee bean hopper empty.
	Brew group not inserted.
	The machine is out of service.
	Coffee grounds drawer full.
	Water tank empty.
	N/A
	The machine is ready to brew products: coffee bean hopper empty
	The machine is ready to brew products: replace the INTENZA+ water fi llter
	The machine is waiting to start the water circuit priming process.
	The milk carafe ducts should be cleaned.
	The machine must be descaled.
	The machine is heating up.
	The machine is rinsing.
	Brew group rebooting.

Machine Out of Service	Description
	If the machine error alarm signal is triggered, the error code is displayed in the bottom right corner of the display. XX (Following table)

Error Code	Behavior	Cause	Action
1	Coffee grinder blocked	Coffee outlet duct clogged	Clean the coffee outlet duct thoroughly.
3 - 4	Brew group locked, cannot be taken out	The brew group is incorrectly positioned.	"Close the service door. Turn the machine off and back on again. Wait for the ‘Ready for brewing’ signal and then remove the brew group."
5	Water circuit error	Air in the water circuit	"Remove and restore the water tank a couple of times, making sure to position it correctly. Check that the water tank seat is clean."

@@ Line 92: / Line 92: @@
 {| class="wikitable"
 |-
-! Error Code !! Behavior !! Cause !! Action|-
+! Error Code !! Behavior !! Cause !! Action
+|-
 | 1 || Coffee grinder blocked || Coffee outlet duct clogged || Clean the coffee outlet duct thoroughly.
 |-