View source for Expobar Office Pulser/cleaning and maintenance

{{Getting-Started
|machine_type = Prosumers
|product_banner = [[File:Wiki_ProductPageBanner_1200x175_ExpobarOfficePulsar_v1.jpg]]
|product_page_title = Expobar Office Pulser
|page_type = maintenance
|section1 = Backflushing
|anchor1 = Backflushing
|section2 = Descaling
|anchor2 = Descaling
|section3 = Grouphead Cleaning
|anchor3 = Grouphead Cleaning
|section4 = Steam Wand Cleaning
|anchor4 = Steam Wand Cleaning
|section5 = Recommended Cleaning Products
|anchor5 = Products
|section6 = Replacing the Group Gasket and Shower Screen
|anchor6 = Group Gasket & Shower Screen

}}
{{Maintenance-Prosumer
|single_heat_exchange = Yes
|group_gasket_instr   = Yes
|descaling_products   = Yes
|softener_info        = 
|backflush_capable    = Yes
}}
===Replacing the Group Gasket and Shower Screen===
{{Content-Columns
|column_1 = 
For the average home user, the group gasket should be replaced about every six months to a year. When the group gasket is worn out, it becomes hard, and no longer creates a good seal between the portafilter and the grouphead, so you may begin to notice some leaking. When a group gasket is really old, it can be extremely difficult to remove from the machine, so even if you don't experience any leaking, replacing the group gasket on a yearly basis is a good idea. The document on the right shows how to replace the group gasket and shower screen. You don't have to replace the screen once a year, as typically it can simply be cleaned. 
|column_2 = 
[[File:Replacing_The_Group_Gasket_On_Your_E61_Machine.pdf|center|link=https://wiki.wholelattelove.com/File:Replacing_The_Group_Gasket_On_Your_E61_Machine.pdf]]
|media_caption = 
Replacing the Group Gasket on Your E61 Machine
}}
----